Replacing a catalytic converter no arrows which is in and out - which way to mount?

Replacing a catalytic converter no arrows which are in and out - which way to mount?


I am going to replace the exhaust from the cat back including the direct fit Walker catalytic converter on my 1993 Toyota Camry 2.2L 4 cylinder. The converter has no marks, arrows or anything showing the direction the converter should be mounted. Both ends of the converter are exactly the same in diameter and could be mounted either way. Anyone have any ideas?|||It would be a lot easier if you know all the steps and watch a video about it.





You need the following for this:





Combination Wrench Set


Jack Stand Set


Socket and Ratchet Set


Socket Extension Set


Mallet Hammer





1. Unbolt the mounting clamps holding the catalytic converter to the pipe.





2. Remove the catalytic converter





3. Clean all mounting surfaces. Remove burrs on the metal pipes to allow the new converter to slide on easier.





4. Install the new converter and tighten the clamps back so that the converter is secure and in place.|||if it is a two stage cat. direction does not matter. if it is a 3 stage, there is a difference.|||93 it dont matter didnt make arrows till 99